Veteran Garage Door Repair | Keller TX | 817-769-8488

Garage Door Opener Repair

You may discover that your garage door opener has been offering you issues, so you need to fix it. You can fix it by changing a circuit card, a photo-eye sensing unit, the main drive gear, or the set-limit buttons. You can additionally check if the safety and security sensing units are working properly.

Changing a circuit card

Replacing a motherboard for your garage door opener needs a couple of actions and also devices. First, you require to shut off the circuit breaker and disconnect any type of wires. Next off, open the circuit board cover. This will certainly assist you to diagnose the issue and identify if you need a new board. Next off, get rid of the old board and also its wire connectors.

You can then proceed to replace the circuit card. The substitute procedure is simple as well as takes around 10 minutes. A brand-new circuit board will certainly set you back regarding $80. To protect your brand-new circuit card from power surges, you can acquire a surge guard.

Changing a photo-eye sensor

Changing a photo-eye sensing unit can be a relatively straightforward task. First, eliminate the sensing unit from the door as well as make sure it is located correctly. If the sensor is angled in any way, it may not be receiving the proper signal, which might be creating the blinking lights. If you discover that the photo-eyes run out alignment, you might require to have actually a specialist come and also repair the trouble.

The photo-eye sensing unit consists of two pieces that place on the outside of the door tracks as well as towards the flooring. The photo eyes will certainly have a small LED light and ought to be strong in shade. If the light is blinking, its most likely the photo-eye is faulty as well as will certainly require to be changed.

Replacing a main drive equipment

To replace a garage door opener major drive gear, start by getting rid of the cap from the chain pulley. Next, remove both screws holding the drive gear to the gear assembly. Currently, you can unfasten the three stress pins. Squeeze them from both sides and after that eliminate them. After that, disconnect the three wires from the garage door opener electric motor. These cables must be white, red, and also blue.

Once you have removed the old equipment, mount a new one. Be sure to grease it well. Put the brand-new equipment right into the shaft, making certain to align the placing openings. Make sure the equipment and gear setting up are positioned appropriately to guarantee smooth operation. Next off, make use of a hammer as well as a nail to drive a pin right into the brand-new equipment.

Readjusting the set-limit switches

The initial thing you must do if your garage door is not functioning properly is to examine the set-limit buttons. You may need to adjust them so that the door closes earlier or quits prior to it gets to the floor. You can examine this by considering your garage doors guidebook or online.

To readjust the set-limit switches, youll require a screwdriver or socket. Change the handle clockwise or counterclockwise till the door goes up and quits, or reduces its range. To check for correct traveling range, determine the void from the bottom of the garage door to the ground.

Veteran Garage Door Repair – Keller

204 S Main St Ste 105, Keller, TX 76248, United States

817-769-8488

https://veterangaragedoor.com/veteran-garage-door-repair-of-keller-tx/


Garage Door Repair


Garage Door Installation


Garage Door Company


Garage Door Service


Garage Door Opener Repair

Veteran Garage Door Repair

204 S Main St Ste 105
Keller,TX
76248
817-769-8488

Leave a Reply

Your email address will not be published. Required fields are marked *


Back To Top